No more 3M masking tape.
No more glue stick!
No more ABS juice.
No replacement for PEI blades.
Easy to print.
Easy to remove by bending and squeezing.
Easy to clean.
Lower operating costs, especially for printing agriculture.
Genuine PEI Powder Coating
Hardened steel spring plate, no bleeding through
Can be added for some cost-effective printers.
* Allows you to add inductive Z-probe
Wipe the print surface with isopropyl alcohol before and after pressure to get a clean surface for maximum adhesion. As with any construction surface, make sure you do not print too close to the bed to possibly insert the filament into the building surface. If you print PETG, TPU, TPE and RYNO, make sure the bed is heated before trying to remove the pressure from the bed.
*It is possible to mount our kits on a larger bed, please note that you have a reduced pressure area. It is also possible to mount our kits on slightly smaller beds; you can carefully cut the magnetic base but the flexi plate sticks over your edges, make sure there are no obstacles like vertical frame elements and it is advisable to have no more than 10mm overhang per side to avoid warping. We cannot be held responsible for wrong order sizes.
How to put it on the printer?
You need to remove the 3M back on the magnetic base, stick the base on the heated bed.
Then place the powder-coated spring steel plate on the magnetic base:
1. Place your LayerLock powder-coated PEI board on the magnetic base of your printer.
2. Align the sheet steel until the edges of the panel are parallel to the edges of the magnetic base pressure bed.
Make sure this fits by entering your model number.
This will be an incredible product, it allows you to experience unparalleled happiness when you pick up your pieces.
Due to the size of the product, it is huge. To control the strength of the bend. We hold a relatively thin thickness. So it is not flat if it is not magnetically adsorbed. When placed in a magnetic bed, it is magnetically adsorbed so that it automatically becomes flat.
Attention: do not print directly on the magnetic base, you need sprint sheet steel with PEI coating. Magnetic base continuous working temperature must be below 105°C.
Package Included:1 x Double Sided Textured PEI Powder Coated Spring Steel Sheet + 1 x Magnetic Base